// file : doc/manual.cli // copyright : Copyright (c) 2014-2017 Code Synthesis Ltd // license : MIT; see accompanying LICENSE file "\name=build2-build-system-manual" "\subject=build system" "\title=Build System" // NOTES // // - Maximum
 line is 70 characters.
//

"
\h0#preface|Preface|

This is the preface.

\h1#grammar|Grammar|

\
eval:         '(' (eval-comma | eval-qual)? ')'
eval-comma:   eval-ternary (',' eval-ternary)*
eval-ternary: eval-or ('?' eval-ternary ':' eval-ternary)?
eval-or:      eval-and ('||' eval-and)*
eval-and:     eval-comp ('&&' eval-comp)*
eval-comp:    eval-value (('=='|'!='|'<'|'>'|'<='|'>=') eval-value)*
eval-value:   value-attributes? ( | eval | '!' eval-value)
eval-qual:     ':' 

value-attributes: '['  ']'
\

Note that \c{?:} (ternary operator) and \c{!} (logical not) are
right-associative. Unlike C++, all the comparison operators have the same
precedence. A qualified name cannot be combined with any other operator
(including ternary) unless enclosed in parentheses. The \c{eval} option
in the \c{eval-value} production shall contain single value only (no
commas).

\h1#module-test|Test Module|

The targets to be tested as well as the tests/groups from testscripts to be
run can be narrowed down using the \c{config.test} variable. While this
value is normally specified as a command line override (for example, to
quickly re-run a previously failed test), it can also be persisted in
\c{config.build} in order to create a configuration that will only run a
subset of tests by default. For example:

\
b test config.test=foo/exe{driver} # Only test foo/exe{driver} target.
b test config.test=bar/baz         # Only run bar/baz testscript test.
\

The \c{config.test} variable contains a list of \c{@}-separated pairs with the
left hand side being the target and the right hand side being the testscript
id path. Either can be omitted (along with \c{@}). If the value contains a
target type or ends with a directory separator, then it is treated as a target
name. Otherwise \- an id path. The targets are resolved relative to the root
scope where the \c{config.test} value is set. For example:

\
b test config.test=foo/exe{driver}@bar
\

To specify multiple id paths for the same target we can use the pair
generation syntax:

\
b test config.test=foo/exe{driver}@{bar baz}
\

If no targets are specified (only id paths), then all the targets are tested
(with the testscript tests to be run limited to the specified id paths). If no
id paths are specified (only targets), then all the testscript tests are run
(with the targets to be tested limited to the specified targets). An id path
without a target applies to all the targets being considered.

A directory target without an explicit target type (for example, \c{foo/}) is
treated specially. It enables all the tests at and under its directory. This
special treatment can be inhibited by specifying the target type explicitly
(for example, \c{dir{foo/\}}).
"